Interpose Non-Adherent Dressing

Interpose Non-Adherent Dressing





A non adherent and absorbent wound dressing for single use. The dressings consists of a central absorbent layer which is sandwiched on both sides by perforated film. This process helps avoid the problems of exudate strike-through. The central absorbent layer is 100% natural cotton. The film is made from high density polyethylene and has consistent porosity with a thickness of 114 micron. This allows the exudates to easily pass through to the absorbent pad. Either side of the dressing can be applied to the wound. 

There are two types of Interpose dressings: Interpose and Interpose Lite. See below for differences.

Physical characteristics of Interpose Dressing

  • Average Weight of the dressings is
    • Interpose: 210 +/- 20 gsm
    • Interpose Lite: 135 +/- 10 gsm

  • Water absorption (AS 2836.6) Water holding capacity:
    • Interpose: Not less than 8 gram/gram.
    • Interpose Lite: Not less than 6 gram/gram.

  • Average sinking time: Less than 10 seconds
  • The cotton absorbent layer meets the requirements of AS 2835.1 1985

    Dressing Specs

    Code Dressing Size  Box Quantity
    30-381 5 x 5cm 100 units
    30-382 10 x10cm 100 units
    30-383 10 x20cm 100 units
    30-385 25 x 25cm 120 units
    30-501 Lite 7.5 x 5cm 100 units
    30-502 Lite 7.5 x 7.5cm 100 units
    30-503 Lite 7.5 x 10cm 100 units
    30-504 Lite 7.5 x 20cm 100 units

    Returns Policy

    There is a 30 day return on any faulty products. To be eligible you must return items at your cost. We guarantee that any product found to be faulty supplied by us, will be accepted for return and we will refund all costs associated with the returned item. Statutory Warranties and conditions of Sale apply in Australia under consumer law for all products supplied by Australian Companies.
    IMPORTANT NOTE: Should any faulty item be a TGA Registered Medical Product or Device, we are required to submit a report to the Registered Manufacturer in accordance with the TGA Legislation. This is a way of ensuring that any device is safely tracked and monitored for safety. We may ask you a few questions and we are required to verify any fault. All standard State & Federal Warranty Conditions apply.


    SOLMED only supplies to Australian Addresses.
    Solmed dispatches all goods via Australia Post or TNT whichever is deemed suitable. We post to all addresses in Australia including Post Office Boxes. Tracking will be notified on Parcels where applicable. Solmed will advise if any product is not available and offer either a substitute, refund or back order.